Accuracy of ancient dating methods

The thermoluminescence technique is the only physical means of determining the absolute age of pottery presently available. It is an absolute dating method, and does not depend on comparison with similar objects as does obsidian hydration dating, for example.

Most mineral materials, including the constituents of pottery, have the property of thermoluminescence TL , where part of the energy from radioactive decay in and around the mineral is stored in the form of trapped electrons and later released as light upon strong heating as the electrons are detrapped and combine with lattice ions.

By comparing this light output with that produced by known doses of radiation, the amount of radiation absorbed by the material may be found. When pottery is fired, it loses all its previously acquired TL, and on cooling the TL begins again to build up. Thus, when one measures dose in pottery, it is the dose accumulated since it was fired, unless there was a subsequent reheating.

If the radioactivity of the pottery itself, and its surroundings, is measured, the dose rate, or annual increment of dose, may be computed. A leaflet from Daybreak describing the TL technique in more detail and giving a bibliography will be provided to interested persons. The phenomenon of thermoluminescence was first described by the English chemist Robert Boyle in While not so accurate as radiocarbon dating, which cannot date pottery except from soot deposits on cooking pots , TL has found considerable usefulness in the authenticity of ceramic art objects where high precision is not necessary.

Since the university laboratories involved with TL are research facilities, they generally will not accept art objects for authentication on a routine basis.

The TL laboratory at Daybreak was established in to make TL available to the art community in general. When dates of a number of sherds associated together are averaged, the error is reduced typically to per cent.

This is for well-behaved samples only. Unfortunately, it is not possible to achieve this precision for the majority of art objects. Among the reasons for this is the small amount of material that may be taken for testing.

Drilling, the usual method of sampling, introduces some uncertainty. It is also rare that any information about the radiation from the burial soil can be obtained, as art objects are usually thoroughly cleaned. This radiation may in some cases contribute over half the total dose. Finally, one has to make the measurements regardless of whether the TL of the clay is well-behaved or not. Some clays are hardly thermoluminescent at all; some may not have a straight-line relationship between dose and TL; spurious luminescence due to chemical or pressure effects may mask the radiation-induced TL; occasionally, a condition called "anomalous fading", where part of the TL is unstable, may lessen the accuracy of the dose measurement.

Generally speaking, when a sample is drilled and there is no information available about the burial environment, one may expect up to 40 per cent uncertainty. This is adequate for the purposes of authentication where the question is whether the piece was fired in antiquity or recently; it will not differentiate, say, between a classic Greek terra cotta and a Roman copy.

In some categories of objects, from China, for example, the actual age is quite precisely known for short-lived styles, and it is possible to work "backwards" to get information about the environment in many parts of the world, and some other parameters not usually measurable for art objects.

Using this information often reduces the uncertainty to per cent. Nearly any mineral material which has been heated above C at a time one wishes to know is a candidate for TL dating.

This includes all forms of pottery. Porcelains, being nearly vitrified, are a special case requiring a fairly large solid core sample, and TL dating of intact objects is not recommended because of the damage caused by sampling. Most porcelain dating is done for insurance purposes on broken objects. Much stoneware is not so hard as porcelain and may be sampled by drilling. The clay cores from lost wax metal castings may readily be tested.

Heated stone material, such as hearths, pot boilers, and burnt flints, has been dated as well. Some regions known to present problems for TL include Indonesia and West Mexico; objects from these areas usually do not successfully yield TL dates. These use pottery of the appropriate period to construct objects.

Some of these are quite easy to detect; some quite difficult. For example figures, normally modeled, may be carved out of brick or assembled out of fragments.

It must be realized that TL dating is but one of the criteria for judging authenticity. The expertise of the conservator may be of equal or greater importance in many cases. Some problem areas include Northern Nigerian ceramics, especially Nok, which are becoming quite scarce.

Ife ceramics are virtually all fake or stolen, if genuine! New Nigerian and Asian bronzes may have introduced old cores, so it is imperative that the interface between metal and core be examined very carefully before the assumption can be made that the age of the bronze is the age of the core.

Chinese unglazed ceramics constructed from fragments or carved from brick are a particular concern. Glazed objects generally cannot be pieced together in this way without re-firing which would defeat the purpose , but be sure the glaze is glass and not a synthetic resin! Often we recommend radiography of objects to ascertain the state of restoration before proceeding with sampling. We reserve the right not to sample and date an object based on concerns about tampering.

Since the TL age is proportional to radiation dose, it is logical to be concerned about the effect of airport security x-rays and radiography done to examine the object. In general it is not a problem. Airport security x-rays devices use very high sensitivity detectors so that the x-ray dose is in fact quite small, perhaps adding a week or month to the age, well below the uncertainty of dating. Radiography, if many films are taken, may be more of a problem, so we recommend that samples be taken prior to exposure.

It may also be possible to compute an approximate correction, but in almost every case the effect is small. Due to concerns about bioterrorism in the wake of the events of this past autumn, the US Postal Service has begun limited sterilization of mail by electron beam.

This will destroy the dose information carried in the pottery and rendered it unsuitable for TL dating. There have been rumors circulating lately about recently fired Chinese pottery being artificially irradiated to circumvent TL dating.

While this is certainly something we watch for, there is little real cause for concern. There are several reasons why this dose tampering is difficult to impossible to achieve successfully.

First, it is difficult to get the dose right without considerable research into the properties of the clay and access to expertise in TL measurements. Second, it is very difficult to get that dose sufficiently uniform over the extent of the entire object.

It also and obviously requires a sophisticated means of irradiation, not easily available here, let alone in China. This fortunate phenomenon is due to the heterogeneity of pottery clays, which are a mixture of fine grains silt and coarser grains sandy inclusions.

The radiation dose we measure in the lab is due to a mix of different kinds of radiation: The major part of the natural radiation dose is due to alpha particles, and the alpha emitting nuclides--uranium and thorium and their daughters--are primarily found in the fine grains.

Because of this, the fine grains have the maximum dose, while the larger sandy grains have that dose only on their surface, and a considerably smaller dose in their interior.

If the different size grains are measured, and the dose is found to be the same, there is good evidence of dose tampering, and the converse is true as well. When all these considerations are taken together, it is extremely difficult to get an artificially dosed object past routine TL dating.

Given the quantity of older pottery available in China, your concerns should be directed more toward pastiches and assembly of new objects out of old fragments. There is one problem area, however, and that is porcelain.

This material is so high fired that it actually becomes a glass with small islands of quartz usually remaining which makes TL dating of porcelains possible. It is unfortunately not practical at this time to do differential dosimetry on porcelain, and it becomes more difficult to tell for certain when irradiation has been attempted.

When the TL test is for routine authentication, a sample of about mg, roughly a third the volume of a pencil-end eraser, is drilled out of an inconspicuous part of the object with a carbide dental burr. If the object is extremely small, the amount of sample may be reduced, but the error margin may increase. It is sometimes preferable to obtain a fragment a half-inch in diameter and a quarter-inch thick, as the precision attainable is greater.

This is advisable whenever the age, if genuine, is less than twice the age of the earliest forgeries. If the object to be tested has been restored, it may be advisable to take more than one sample, as the component parts may differ in age. For heavily restored objects, or those where construction from diverse fragments is suspected, we have taken up to ten samples there will be a modest increase in the fee for samples in excess of two.

The site of the samples may easily be restored if desired. First, you should contact Daybreak to discuss the advisability of testing and to arrange sample-taking. We make occasional trips to New York City for this purpose; travel elsewhere is by arrangement.

One photo is retained in our files for reference; the other is annotated with the result, signed, and returned with the test result. Polaroid snapshots are adequate; it is necessary only that the object be readily identifiable from its picture. If the sample is taken by anyone other than Daybreak or its representative, it is recommended that the sampling be witnessed as provided for on the Sample Submission form , asserting that the sample is indeed from the object depicted in the photographs.

The sample-taker must sign both photos. It is extremely important to note whether the object is known or is suspected to have been exposed to x-rays or neutrons, as this could alter the results. Exposure to airport security x-rays does not present any problem. Also, if the piece has been heated for some purpose during restoration, the TL result may be affected. In either case, consultation is required to determine whether the object can be accepted for test.

Please be assured that all information about objects submitted is held in the strictest confidence. We also have conservators and restorers located throughout the country who can take samples for us at an additional charge. We recommend registered mail as a means of shipment, as the cost of insurance is very reasonable. Please consult us about packing methods.

Usually test results are available verbally within three weeks after the sample arrives at Daybreak, with the written report to follow. Rush service as soon as the next day may be available at a premium, if our schedule permits. A large number of samples submitted as a group may take longer. There may be a modest extra change for a larger number of samples. We are now charging for sample taking: You will pay return shipping of any object sent to us.

Quantity rates for dating are available for objects submitted in groups of five or more at the same time: In case of travel outside the immediate area i. For further information, please contact Dr. Victor Bortolot, our technical director.


FREQUENTLY ASKED QUESTIONS How does thermoluminescence dating work? What is the accuracy of TL dating? What materials can be dated by TL? Warning about fakes using ancient materials. Radiometric Dating. How radiometric dating works in general. Why methods in general are inaccurate. Why K-Ar dating is inaccurate. The branching ratio problem.

Total 1 comments.
#1 13.10.2018 в 15:31 Ctheczar718:
Pisaka a half-wit